doctorasg.blogg.se - Vu zero 4k cccam install

To find out, you need to go to the section MENU -> Information -> NetworkĬonnection status must be Up / Active, IP address must be defined (In my case it is 192.168.1.219) To do this, go to the MENU -> Setup -> Reception -> Tuner Configuration section and configure your tuner.ģ.2 Obtaining the IP address of the receiverīy default, the receiver should obtain a network address automatically (DHCP). If, after flashing and turning on the receiver, the “ kabel eins” channel did not work for you, then you need to change the tuner settings. Now you can start to configure the Zero 4K.

Power off the receiver, remove the USB stick, and power on the receiver again.

Once completed the WHITE VU+ logo will flash rapidly.

The WHITE VU+ logo will quickly flash two or three times then start to fade in and out slowly.

Insert the USB stick containing the image files into one of the USB ports on the receiver, rear USB port is advised if possible.Ensure no other USB devices are plugged into the receiver while flashing.

The result is that you get a directory vuplus and in this directory you find a directory zero4k in which you find the necessary files. zip archive) on your PC using your favorite unzip tool to the root directory of your USB stick.

Format your USB stick with a FAT32 file system.

If you don’t have a Vu+ Zero 4k receiver, please use other article! 2. Therefore, before installing, we strongly recommend that you make a full backup of your receiver!Īfter installing the firmware, you will need to make some settings – if necessary, change the configuration of your tuner, as well as specify your data for connecting to the CS server. We have prepared for you a ready-made OpenATV 7.0 firmware with Oscam iCam v3 installed and configured for Vu+ Zero 4k (ARM cpu)Īttention! After installing the firmware, all data on your receiver will be deleted! Including your scanned channels, etc.